-40%
Hantek HT301 Vehicle Sensor 2-pin Break Out Leads For Hantek Oscilloscope
$ 6.83
- Description
- Size Guide
Description
This breakout lead is easy to take voltage readings from numerous sensors in vehicle engine compartment. Connect the breakout lead plugs into the existing wire loom, and insert the two 4mm banana plugs into the oscilloscope using test lead HT30A, the output signal can be taken. Following sensors can be connected: Multi-point injection nozzle Single-point injection nozzle Induction crankshaft sensor or camshaft sensor The temperature sensor Knock sensor GM ignition coil Lk hua ignition module Bosch mechanical injection system - warm-up regulator, subsidiary air valve, temperature timer switch, cold start nozzles. Lead Length: Red: 300mm Yellow: 900mmThis breakout lead is easy to take voltage readings from numerous sensors in vehicle engine compartment.
Connect the breakout lead plugs into the existing wire loom,
and insert the two 4mm banana plugs into the oscilloscope using test lead HT30A, the output signal can be taken.
Following sensors can be connected:
Multi-point injection nozzle
Single-point injection nozzle
Induction crankshaft sensor or camshaft sensor
The temperature sensor
Knock sensor
GM ignition coil
Lk hua ignition module
Bosch mechanical injection system - warm-up regulator, subsidiary air valve, temperature timer switch, cold start nozzles.
Lead Length:
Red: 300mm
Yellow: 900mm
Contents:
HT301 Breakout Lead
On Mar-25-21 at 04:29:05 PDT, seller added the following information: